Tools/ABC Tool/ABC Accessories/Tool/Working Tools/Wedge Connector Tools/C Connector tool

Installation pictures: 1.jpg 1.Preparation: withdraw the rear seat of the trigger and load suitable bullets into the chamber; pull the hitting needle in place and then tighten the rear seat; screw the trigger to the corresponding clamping die and clip on. 2.jpg 3.jpg 2. According to the above two pictures correctly install the gun with the connector. Pay attention to it that the back seat of the gun must be tightly contacted with the wedge core. (For safety considerations, if the former putter is not tightly contacted, bullets can’t be fired) 4.jpg 3. When press the button, bullets are fired. The front putter will push the wedge core into the connector to successfully install it. (If first firing fails, there can be second firing. Before second firing, back seat needs to be tightened again in case that it has not been tightened in the first firing.) 5.jpg 4. The convex of the front end of the clamping die will automatically change the wedge core into an anti-bump, to ensure long-term operation and maintain long-term pressure.